Basics
Category | Combines |
---|---|
Manufacturer | John Deere |
Model | 9770 STS |
Model Year | 2008 |
Operation Hours | 4756 |
Stock Number | 88147 |
Serial Number | H09770S726412 |
Status | On Lot |
Key Features
Combine Type | Corn/Bean |
---|---|
Axle | PRWD |
Duals/Singles | Singles |
Chopper/Spreader | Chopper |
Options | Yield Monitor |
Options | Contour Master (Lateral Tilt Feederhouse) |
Header | No |
Premier Cab | |
Contour-Master Feederhouse with Reverser and High-Torque Variable Speed Drive System | |
2.75 In. (70 mm) Feederhouse Lift Cylinders and High Capacity Hydraulic Pump | |
Premium Header Control Package | |
GreenStar AutoTrac Ready Wiring Harness and Steering Components with Harvest Monitor System LESS GreenStar Display | |
Custom Cutters Extended Wear Concave and Extended Wear Separator Package | |
General Purpose Adjustable Chaffer and Bottom Sieve | |
General Purpose Grain Handling System with High Capacity Unloading System and 22.5 Ft. (6.9M) 1-Piece Perforated Unloading Auger (Not available for Export) | |
Wing Blade Wide-Spread, Fine Cut, 2-Speed Chopper with Integrated Chaff Spreader and Single-Point Adjustable Knife Bank | |
Heavy-Duty Final Drive and Heavy-Duty Hydrostatic Drive System | |
900/65R32 R1W Radial | |
Adjustable Rear Axle with Heavy-Duty Spindles | |
750/26 In. 10PR R1W | |
Engine Coolant Heater - 110 Volt (Not available for Export) | |
Feed Accelerator Slow Speed Drive | |
Sectionalized Concave Cover Plates (Set of 2 with 3 pieces in each section) for Large Wire and Small Wire Concaves only | |
Perforated Elevator Boots, Doors, and Clean Grain Cross Auger Trough |